Cabin door molding pulling off.

skennellyskennelly Member Posts: 2,196 ✭✭✭✭
in Rinker Express Cruisers Forum
My 270 has a rubber molding that goes around the cabin door.  Since I've owned the boat it's been pulling off and people inevitably grab it when going down into the cabin.  Looking on suggestions on how to secure it.  Adhesive doesn't seem like it would work.  I bought some stainless screws...but doesn't seem like the gasket covers enough of the fiberglass to screw into.

Thanks.
2002 - 270FV Mag 350 B3
· Share on FacebookShare on Twitter

Comments

  • WillhoundWillhound Member Posts: 4,208 ✭✭✭✭✭
    Had the same issue. It also seems that over time it shrinks a bit and the corner would always come off. I used a heat gun (gently) to give it some stretch and then a two part epoxy which held until I sold the boat.
    "Knot Quite Shore" - 2000 FV270 (Sold)
    2018 Cherokee 39RL Land Yacht (Sorry...)
    · Share on FacebookShare on Twitter
  • skennellyskennelly Member Posts: 2,196 ✭✭✭✭
    @Willhound - thanks.  I thought about taking a heat gun to it.
    2002 - 270FV Mag 350 B3
    · Share on FacebookShare on Twitter
Sign In or Register to comment.