quick question re riser bolt

halifax212

I just reinstalled riser and torqued to 35lbs in three stages. all has gone well but forgot to attach the 20 amp breaker. Can I remove the bolt and re torque or leave it and tie it off somewhere?

212rowboat

Womt hirt anything. Pull and reinstall bolt. 

halifax212

thanks Drew

F1100

Check if they are torque to yield single use, or reusable

halifax212

They are the original @F1100.  I had a parts guy at a local dealer say I could reuse a few weeks ago. I will check again tomorrow when I go over for a set of exhaust flappers to be sure. Thanks for the heads up.

F1100

If you have a manual, they will either have a TTY symbol, or a "x" near pointing to them if they cant be reused.. in most cases anyway..or some mention that the bolt is 1 time use 

halifax212

Thanks @Alswagg @F1100.  Riser castings still looked good. It is always flushed after use in the salt and average 30 hours per season. Exhaust shutter was stuck in closed position (50% free). Replacing that this weekend then that's it for the season.