2005 FV 320 engine overheat

atlastatlast Member Posts: 10
yesterday while were out my starboard engine overheated .Background - we were running pretty close to idle speed for about 4 hrs when the starboard side 5.0 overheated . It was running fine and at temp up in till then .  Wasn't running hot at all . Not sure if this has anything to do with it but right before it overheated a boat with a fairly large wake went by us and swamped the swim platform .My thought is it sucked something up but not sure how to check for it . The boat is in a marina and I don't have access to pull it out .  Any suggestions ?

Comments

  • BabyboomerBabyboomer Member Posts: 918 mod
    Bravo impeller how long has it been since it was changed

    Slip 866 Sunset Marina Byrdstown Tn
  • atlastatlast Member Posts: 10
    It was changed about a month and half ago . 
  • 212rowboat212rowboat Member Posts: 2,593 ✭✭✭✭✭
    might want to pull the feed and see if it sucked something up in it... it could be that a piece of somethingsomething is either limiting the flow or is keeping it from spinning... or, maybe even broke it..
  • BabyboomerBabyboomer Member Posts: 918 mod
    Have you checked the recirculating pump on front of the engine the water pump is like the one on your car that the fan is bolted to I had one go bad last year they start off leaking shows rust on front

    Slip 866 Sunset Marina Byrdstown Tn
  • Lifes GoodLifes Good Member Posts: 465 ✭✭✭
    If you find no blockages then try tightening the seaclamps on the water pump hoses. Over time the hoses get softer and need to be tightened. The water pump creates a huge vacuum and if the clamps are slightly loose air gets sucked in. Hence the air bubbles get super heated and increase the engine temp... I have had this happen twice so now I double clamp the water pump hoses.
  • BabyboomerBabyboomer Member Posts: 918 mod
    All Marine hoses should be double clamped

    Slip 866 Sunset Marina Byrdstown Tn
Sign In or Register to comment.