Spare Parts Kohler 5E Generator

Comments

• grouch0jr Member Posts: 15 ✭

  July 28

  I've found spare parts on the following site, I didn't see the entire assembly for the control box, but it looks like they have the control board pcb:
  
  https://www.partsfortechs.com/index.php?main_page=index&cPath=14_83_408

  2006 342EC

  0 · Share on FacebookShare on Twitter
• rasbury Member Posts: 8,585 ✭✭✭✭✭

  July 28

  Have you just checked with Kohler? Don't mean to ask a stupid question...I haven't made a lot of purchases but including the anode I was able to get tune up parts from them...

  0 · Share on FacebookShare on Twitter
• McGarnicle Member Posts: 250 ✭✭✭

  July 28

  grouch0jr said:

  I've found spare parts on the following site, I didn't see the entire assembly for the control box, but it looks like they have the control board pcb:
  
  https://www.partsfortechs.com/index.php?main_page=index&cPath=14_83_408

  This is where I’ve ordered parts for my Kohler from. 

  0 · Share on FacebookShare on Twitter
• rasbury Member Posts: 8,585 ✭✭✭✭✭

  July 28

  Has anyone else experienced the frame rotting out and a solution? It just makes me sick looking at it and just not sure what to do with it. I will book mark that link- thanks. 

  0 · Share on FacebookShare on Twitter
• PickleRick Member Posts: 4,147 ✭✭✭✭✭

  July 29 edited July 29

  Box it up,  ship it to South Carolina this fall. Got a metal supplier down the road.   
  
  I'll ship you a new one back coated in POR.   Use the old to make an exact replica. 
  
  Not sure how you plan on removing it,  some of those gensets require engine removal before the generator can be pulled out.   The Genny alone is probably 200lbs

  3 · Share on FacebookShare on Twitter
• rasbury Member Posts: 8,585 ✭✭✭✭✭

  July 31 edited August 8

  @PickleRick unfortunately that is the solution. I did pull the motor by undoing everything and go to the local marina to use their fork lift. I think it would come out but you'd have to be able to tilt it. I'm about ready to remove/ cut out as it really serves no purpose to me. The frame, not the generator.

  Post edited by rasbury on August 8

  0 · Share on FacebookShare on Twitter
• tricountytrail Member Posts: 219 ✭✭

  August 7

  Well plans have changed if anyone needs a running generator message me.
  
  

  0 · Share on FacebookShare on Twitter