quick question re riser bolt

halifax212 · May 2018

I just reinstalled riser and torqued to 35lbs in three stages. all has gone well but forgot to attach the 20 amp breaker. Can I remove the bolt and re torque or leave it and tie it off somewhere?

Image: https://us.v-cdn.net/5020499/uploads/editor/g1/2xnmhs5hwk8q.jpg

212rowboat · May 2018

Womt hirt anything. Pull and reinstall bolt.

halifax212 · May 2018

thanks Drew

F1100 · May 2018

Check if they are torque to yield single use, or reusable

halifax212 · May 2018

They are the original @F1100. I had a parts guy at a local dealer say I could reuse a few weeks ago. I will check again tomorrow when I go over for a set of exhaust flappers to be sure. Thanks for the heads up.

F1100 · May 2018

If you have a manual, they will either have a TTY symbol, or a "x" near pointing to them if they cant be reused.. in most cases anyway..or some mention that the bolt is 1 time use

halifax212 · May 2018

Thanks @Alswagg @F1100. Riser castings still looked good. It is always flushed after use in the salt and average 30 hours per season. Exhaust shutter was stuck in closed position (50% free). Replacing that this weekend then that's it for the season.

Howdy, Stranger!

Quick Links

Categories

quick question re riser bolt

Comments