Trailer bunk measurements for 2003 FV310 era

Ian

Greetings. I picked up a trailer for my 2003 310 recently for yard use (although is a road trailer) mainly for store at my club. I am planning on lifting the boat Friday and hanging over the trailer to align the bunks appropriately rather than pull up and down the ramp. Anyone with a 310/312 around the same era out the water and offer some measurements off the hull to give me a starting point? @Nick_03FV310 @Pat310 @Aprice

Pat310

Wish you would have asked last week. Boat went back in last week with rebuilt engine finally installed

PickleRick

If you can't get measurements from anyone with a boat out of water take a measurement of the gap between stingers in your engine room.  They give the most support.   Space your rear boards there, or as close as possible.  Depending on hull shape/step you may need to tilt/space accordingly.  

Ian

Pat310 said:

Wish you would have asked last week. Boat went back in last week with rebuilt engine finally installed

Stupid me only thought about asking here yesterday. When you coming back out as as you’re not too far south of me.

Ian

Thanks @PickleRick good idea as a starting point.