Trailer bunk measurements for 2003 FV310 era

IanIan Member Posts: 3,062 ✭✭✭✭✭
edited October 2023 in Rinker Express Cruisers Forum
Greetings. I picked up a trailer for my 2003 310 recently for yard use (although is a road trailer) mainly for store at my club. I am planning on lifting the boat Friday and hanging over the trailer to align the bunks appropriately rather than pull up and down the ramp. Anyone with a 310/312 around the same era out the water and offer some measurements off the hull to give me a starting point? @Nick_03FV310 @Pat310 @Aprice

Regards,

Ian

The Third “B”

Ravena Coeymans Yacht Club

https://www.rcyachtclub.com/

· Share on Facebook

Comments

  • Pat310Pat310 Member Posts: 604 ✭✭✭
    Wish you would have asked last week. Boat went back in last week with rebuilt engine finally installed
    · Share on Facebook
  • PickleRickPickleRick Member Posts: 4,341 ✭✭✭✭✭
    If you can't get measurements from anyone with a boat out of water take a measurement of the gap between stingers in your engine room.  They give the most support.   Space your rear boards there, or as close as possible.  Depending on hull shape/step you may need to tilt/space accordingly.  
    · Share on Facebook
  • IanIan Member Posts: 3,062 ✭✭✭✭✭
    Pat310 said:
    Wish you would have asked last week. Boat went back in last week with rebuilt engine finally installed
    Stupid me only thought about asking here yesterday. When you coming back out as as you’re not too far south of me.

    Regards,

    Ian

    The Third “B”

    Ravena Coeymans Yacht Club

    https://www.rcyachtclub.com/

    · Share on Facebook
  • IanIan Member Posts: 3,062 ✭✭✭✭✭
    Thanks @PickleRick good idea as a starting point.

    Regards,

    Ian

    The Third “B”

    Ravena Coeymans Yacht Club

    https://www.rcyachtclub.com/

    · Share on Facebook
Sign In or Register to comment.