2001 Captiva 212 Swim Platform mounting

jflanigan

I purchased an OEM swim platform for my 2001 Captiva 212 BR with a walk through transom from Great Lakes Skipper. Rinker no longer had the molds and sold their remaining ones to them. Does anyone have this type (mounts on top of the built in swim platform) and if so, can you let me know if there are brackets that go underneath? The only attachment points that are built in are the 4 threaded rods shown from below. There does not seem to be any place to install an exposed bracket. Rinker's part department tell me that bracket #2200630 is the right one to use, but they cannot answer how it is installed.
Thanks for any help offered,
Jeff

nighthawk73

On my 05 it has the 4 molded in studs and the two under support brackets that you have pictured. The support brackets are through bolted and then appear to just have stubby screws into the platform.

jflanigan

Thanks for the reply - is there any chance you could take a picture from below so I can better understand where those brackets actually attach? 

nighthawk73

Wont be at my boat for a few days but look at the very last photo in this thread.

https://rinkerboats.vanillacommunities.com/discussion/645/smart-tabs-installation-question-2006-rinker-226-captiva

jflanigan

Awesome, thank you very much. I think I can figure it out from that picture.