Need Help Identifying Some Wires

aero3113

@YYZRC , I was thinking the same since you said yours is mounted on the port side near the AC outlet.

YYZRC

Where is the breaker for the macerator? At the battery switch?

aero3113

YYZRC said:

Where is the breaker for the macerator? At the battery switch?

It could be, I haven’t noticed since I don’t have one installed. I’ll have to look.

Cableguy Greg

YYZRC said:

Where is the breaker for the macerator? At the battery switch?

It should be at the battery switch. 

YYZRC

aero3113 said:

YYZRC said:

Where is the breaker for the macerator? At the battery switch?

It could be, I haven’t noticed since I don’t have one installed. I’ll have to look.

If that molex under the charger is indeed for the macerator, you must have a breaker for it somewhere!

Speaking of these molex connectors, where do I buy some? I tried searching amazon but it was a nightmare of options. 

aero3113

@YYZRC , I got them on eBay from this seller.

https://www.ebay.com/itm/382691867903

aero3113

@YYZRC , your supposed to use special crimpers for the pins but you can use a a pair of needle nose pliers to bend them over, just try to overlap them when you do. If not done correctly with the pliers the crimp can be too wide to fit into the connector.

aero3113

Yes, macerator breaker is on the battery panel.

YYZRC

I guess you could short it and see if that's the breaker that pops!

YYZRC

Do the port and starboard batteries have to be "on" (green light lit) for them to charge?

aero3113

I don’t know but I think the switch can be off and the charger on to charge. With my 242 I always turned the battery switch off. With the 330 I want to get used to leaving it on like most do.