Best Of
Re: New Vibration Issue
@raybo3 and @PickleRick are right -- you need to isolate the problem. If you put the old props back on and there's no vibration, get Hill to replace the 4x4 set.
LaRea
1 ·
Re: New Vibration Issue
That's what I was wondering. The boxes looked fine but maybe one of the props is not balanced??
skuter99
2 ·
Re: Toilet Backingwashing question
There should be a joker valve in line (check valve). It’s rubber and usually needs to be replaced every couple of years.
aero3113
3 ·
Re: Project: Folding steps for the engine room
Great idea. I have no problem getting in to the engine compartment but at my age and flexibility getting out is a problem, I will be looking behind the bulkhead to see what's there.
Grahamu
1 ·
Re: Project: Folding steps for the engine room
What do you mean by the bulkhead being too far forward? The hatch opening has an overhang on the forward side?
I always liked the nonskid they put on top of the risers. Not.
I always liked the nonskid they put on top of the risers. Not.
LaRea
1 ·
Re: Project: Folding steps for the engine room
Very nice. I know my bulkhead would be a little too forward to do that. But, my step down is a little higher and works ok for now. I like that upgrade!
Dream_Inn
1 ·
Re: Project: Folding steps for the engine room
Definitely. The original step was way too low. I always hated making that "leap of faith" to get my foot onto the step.
I used the new steps a lot yesterday. Much, much better.
I used the new steps a lot yesterday. Much, much better.
LaRea
1 ·
