Rinker 350/360 2007+ Random Topics

YYZRC

I’m hoping to do the top in white - waiting for paint to arrive!

aero3113

Nice @YYZRC ! How did you secure the racks?

YYZRC

Removed the seat back and used two 2.5” #10 stainless screws on each rack. 

YYZRC

The H3O+ works well. 

oscar1

Awesome 

aero3113

Very nice @YYZRC !!

oscar1

YYZRC:
 You look ready for ICW cruise down to Florida 

YYZRC

New fridge is in. Now to build a new cabinet!

YYZRC

Got the rear wash down receiver installed. 

YYZRC

aero3113 said:

Nice @YYZRC ! How did you secure the racks?

@aero3113 in case you decide to do this, make sure your notches are at least 45 degrees or the stuff will fall out when you open the engine hatch. I did 45 and it’s just barely steep enough. 

aero3113

Thanks @YYZRC !!
Its on my list, will be great for my kayak and paddle board paddles.

YYZRC

tricountytrail

Any one have a part number or source for these hinges?

YYZRC

New blower ducts finally. 

Spyderweb

Ooh, that looks nice.

aero3113

Nice @YYZRC , I did that when I first bought the 330. Are you going to put the water/sand diverters on the hatch?

aero3113

This is what the previous owner was running with!😳

YYZRC

No, I hate those things. I was originally planning to do a PVC elbow and pipe to divert but have since decided to do nothing. I don’t put anything wet in the locker. 

I ordered these for the inside of the locker:

aero3113

Nice

YYZRC

I needed some replacement snap buttons that match the interior upholstery on my boat.  These are perfect and should match any 2008 330/350.

https://www.greatlakesskipper.com/fasnap-boat-snap-buttons-btn30snap-rinker-white-3-8-inch-set-of-25

YYZRC

Got the switch panel for the hardtop romance light installed. Included a USB charging port and the cig lighter port for inflating paddle boards. 

aero3113

Nice @YYZRC !!

YYZRC

I had two made, you want this one @aero3113 ?

YYZRC

Added an extension to the stringer shelf so I can move around easier. 

aero3113

YYZRC said:

I had two made, you want this one @aero3113 ?

No, but thanks! I’m thinking about putting in a USB socket somewhere near the aft seating area in the cockpit on the starboard side. I could just run a longer charging cord from the helm but obviously it would look cleaner with the USB socket.

YYZRC

Cabinet is built and in. Waiting on the SS panel and trim. 

YYZRC

Found a nice faucet on Amazon Warehouse deals!

YYZRC

Did the head faucet, too. 

aero3113

Very nice @YYZRC , is it a direct swap since it only has the one hot/cold handle?

YYZRC

Yep! Didn’t even need to enlarge either hole. This is much better for the skipper.