What did you do to your boat today

Ian · May 2020

I got to take her for a shake down run - and went well.

PickleRick · May 2020

Lined up a 1990 ish 5.7 block and some newly reworked vortec heads with stainkess valves...just in case.

rinker270nb · May 2020

I use a tablet to run Vesselview and Bluetooth music to the stereo. I finally secured it to my helm.

Cableguy Greg · May 2020

Replaced my refrigerator door.

aero3113 · May 2020

Looks great , @Cableguy Greg . I guess you finally received it!

Cableguy Greg · May 2020

aero3113 said:

Looks great , @Cableguy Greg . I guess you finally received it!

Yes, showed up yesterday. One minor issue is that it hits the light switch and makes it a little difficult to open.

aero3113 · May 2020

@rinker270nb , looks good. I got an anti glare screen protector for my ipad , it really helps.

rinker270nb · May 2020

@aero3113 great recommendation on anti glare. I will try it out.

PickleRick · May 2020

getting her up to temp. Fingers crossed all is good.

PickleRick · May 2020

Ran through 3 or 4 heat cycles on muffs and did compression test.

160 to 170 on all cylinders. Im sure with the age of my motor (88 model) i have some oil burn that is assisting with higher compression numbers but with all these so close across the boats im happy.

If have been happy with 145 to 150 across the board with this factory low compression engine.

YYZRC · May 2020

Cableguy Greg said:

Replaced my refrigerator door.

Did you order thru Dometic directly? They referred me to some random company.

PickleRick · May 2020

Get a little water in the crank case and it takes forever to get out. With all power killed i flushed with 2 cycle mixed fuel, then with atf. Stopped for lunch.

Will change oil and filter then run for good 20 min on muffs then change again. Should be good to go after that.

J3ff · May 2020

Willhound said:

Finally in! New gimbal bearing and seal. No more chug chug noise. Have to stand the antenna and all round light up, install new tv antenna. Cushions and mattress go in Friday.

How long did you run on the chug chug and what did the bad one look like?

PickleRick · May 2020

He's in Canada, his boating season is 3 weeks long compared to yours in the keys, he could go years on chug chug chug 😅😅😅😅

Willhound · May 2020

@J3ff I ran it like that 2/3d's of last season. About 60 hours run time and almost all at speed.I didn't see the bearing out, looking at it in place with the drive off it looked fine.
Much quieter now. First real run out of the marina will be Monday.

Aqua_Aura · May 2020

60 hours in a Canadian boating season is a ton of time!!!!

PickleRick · May 2020

Hey @J3ff if you want to borrow my alignment bar ill bring it with me on our keys trip, you can keep it for the week we are down there. Ship it back to me if you need it longer.

We can socially distance and i can leave it on my bumper. Or man up and meet us for a beer or three.

J3ff · May 2020

Mine isn't making any noise in gear... still haven't gotten the part, took it 30 miles today... no new noise, going to do it again tomorrow... hope it makes it just fine

PickleRick · May 2020

You have less than a month to let me know!

Cableguy Greg · May 2020

YYZRC said:

Cableguy Greg said:

Replaced my refrigerator door.

Did you order thru Dometic directly? They referred me to some random company.

Cruiseair out of Annapolis is who I ordered through.

YYZRC · May 2020

Thanks!!

PickleRick · May 2020

Trouble free day on the lake!!!

Spyderweb · June 2020

My storage marina has finally opened to let boat owners work on their boats, but only during off hours. Went to boat Sunday (100 mile drive) and buffed and waxed starboard black, and installed two "new" 22P bravo 3 props, so I now have 22P all around, instead of a mismatched set of 22P and 20P. Also began prepping drives for primer in corroded areas.

Image: https://us.v-cdn.net/5020499/uploads/editor/ki/621nw7iqemtu.jpg

Image: https://us.v-cdn.net/5020499/uploads/editor/za/p4fcszt3qjiq.jpg

Willhound · June 2020

Nice work!

aero3113 · June 2020

My wife bought a portable crib for the baby. I was tired of bringing the playpen we have at the house back and forth!

aero3113 · June 2020

This is what we were using.

rasbury · June 2020

I wish my boat was big enough to put a play pen in...as it is, it is a play pen!

PickleRick · June 2020

@rasbury...your 270 is a yacht compared to my 235....id have room for a diaper bag!
Its easy to feel the need for a bigger boat on this fourm

TonyG13 · June 2020

Ahhh, the good old pack-n-play! I remember those times well.

Aqua_Aura · June 2020

My wife and I just did away with having kids all together so we can avoid these dilemmas 😆

Howdy, Stranger!

Quick Links

Categories

What did you do to your boat today

Comments